To change the Date in the CLICK CPU module, use the following system Data Registers to set new Date. Note: These system Data Registers are Read Only. The CLICK CPU module stores the Date information in the following system Data Registers: Note: If the CLICK PLC is protected by a password, the ‘ Change Date and Time in PLC’ option must be unchecked in the Password Setup (Pull down menu: Setup > Password Setup…) as shown below in advance to change the Date and Time via a com port. However, the following four CLICK CPU modules don’t support it. Note: The most CLICK CPU modules support the real time clock feature. Note: This feature is supported from CLICK CPU firmware V2.00. The Date and Time can be changed when the CLICK PLC is in either RUN and STOP modes. This help topic explains how to change the Date and Time in the CLICK CPU module without using CLICK Programming Software.
0 Comments
Leave a Reply. |